WALLPAPER INSTALL GUIDE

Peel & Stick Wallpaper Installation Guide

TOOLS & MATERIALS

  • Measuring Tape

  • Level or Laser Level

  • Pencil

  • Utility Knife or Scissors

  • Squeegee or Wallpaper Smoother

  • Ladder/step stool (if needed)

STEP 1: PREPARE THE SURFACE

  1. Ensure the wall is smooth, clean, and dry. Remove dust, dirt, and any grease. 

  2. Patch holes or cracks and allow the surface to dry completely.

  3. Avoid applying wallpaper on textured walls, as it may not adhere properly.

  4. We recommend testing a small, inconspicuous area before applying the wallpaper to the entire surface.
  5. Please note, any mold or mildew on a wall may be an indication of a moisture problem. The mold itself must be removed from the wall and any sources of moisture accumulation must be corrected before proceeding with the installation.
STEP 2: MEASURE AND CUT

  1. Measure the height and width of your wall.

  2. Mark a straight vertical guideline using a level and pencil to ensure the first panel is aligned properly.

STEP 3: APPLY THE FIRST PANEL

  1. Peel off a small section of the backing at the top.

  2. Recommended to do the easiest section of the wall first.

  3. Align the wallpaper with the guideline and press the exposed adhesive section onto the wall.

  4. Gradually peel off more backing while smoothing the wallpaper down with a squeegee or smoother.

  5. This peel & stick is re-positionable! If you need to readjust the placement, simply peel it off the wall and reapply.
STEP 4: APPLY ADDITIONAL PANELS

  1. Align the next panel with the edge of the first, ensuring pattern alignment if applicable.

  2. Overlap edges where needed - all wallpaper is printed with a 1 inch overlap to allow for easy installation.

  3. Continue peeling and smoothing each panel until fully adhered.

STEP 5: TRIM EXCESS WALLPAPER

  1. Use a sharp utility knife or scissors to trim excess wallpaper at the ceiling and baseboard. HIGHLY recommend a SHARP blade for each cut.

  2. Smooth down edges to ensure a secure hold.

STEP 6: FINISHING TOUCHES

  1. Check for air bubbles and gently press them out with a squeegee or smoother.

  2. If repositioning is needed, carefully peel back and adjust.

  3. Allow wallpaper to settle for a few hours before moving furniture back.

REMOVAL TIPS !!!
  • To remove this product from the wall, pull one of the top corners from the wall and draw the material down against itself on a 180° angle with at a slow and consistent speed until the panel is completely removed. Proper prior surface preparation should ensure complete removability without any damage to the wall surface.

  • If adhesive residue remains, wipe with a damp cloth and mild soap.

  • Lucy White Atelier, LLC is not responsible for any damages upon removal. 
ENJOY !!!! XOXOXO

 

PLEASE NOTE: Lucy White Atelier, LLC is not liable for any incorrect installation. Follow the install guide below for the smoothest and most simple application. Please consult a professional installer at your own discretion.

For professional installers in your area, find a guide HERE.

While this peel-and-stick wallpaper is designed to be removable, we cannot guarantee that it will not cause damage to all wall surfaces. It is the responsibility of the customer to ensure that their wall is properly prepared and to test the product on a small, hidden area of the wall before full application. By purchasing, you accept that Lucy White Atelier, LLC is not responsible for any damage caused to the wall or property during the application or removal process.